Skip to content

Miscellaneous Notices to Mariners

5 Electronic Navigational Charts (ENC)

In connection with new surveying of the Norwegian coast, the Norwegian Hydrographic Service is prioritizing the publication of electronic navigational charts authorized for navigation. The international designation of such charts is ENC (Electronic Navigational Chart).

ENCs are produced in accordance with the International Hydrographic Organization's (IHO) S-57 standard, which is applied by all hydrographic offices world-wide for the production of corresponding electronic navigational charts for their waters.

ENCs for the entire Norwegian coast are available through authorized PRIMAR distributors. Information about coverage and overview of distributors is available from

5.1 Electronic Chart Display and Information System (ECDIS)

ECDIS is a certified navigation system meeting SOLAS requirements to navigational equipment pursuant to certain criteria. If an ENC is installed on this type of system and kept updated, it may be used for navigation in the same manner as an updated paper nautical chart.

Other types of unofficial electronic charts, for example charts produced by private industry or raster charts, can only be used as a supplement for navigation.

The following back-up systems are approved for use on Norwegian vessels:

  1. Updated paper nautical charts, or
  2. ECDIS No. 2 connected to an emergency power source.

IMO requirements for mandatory use of ECDIS

In 2008, the International Maritime Organization's (IMO) Maritime Safety Committee (MSC) approved provisions regarding the mandatory use of ECDIS. The implementation phase will cover the period from 2012 to 2018, depending on the type of vessel and its size.

5.2 Official Norwegian Electronic Navigational Charts (ENC) for Norwegian Waters

Official electronic navigational charts (ENC) are vector charts produced in compliance with the specifications given by the International Hydrographic Organization, and are approved by a national hydrographic office.

The sources for Norwegian ENCs are either digitalized or scanned analog charts, or a database. The data is compiled into a seamless database in which each ENC is a cell. Each cell is identified by a unique number.

The content of charts and ENCs in the same area is not always identical. The ENC often contains more detailed data.

Depths along the quay

Quay depths are taken either on the quay or two meters away from the quay depending on when the measurements were taken. The position of quay depths maybe presented slightly away from the quay in the electronic navigational chart (ENC) in order to improve readability in ECDIS.

Update Files (ER Updates)

An advantage with ENCs is the possibility for automatic updates. Update files (ER) are issued every fortnight. Within a 14 day period, all notices from the last Etterretninger for Sjøfarende (Efs) will be included. The ERs may also include updates that have not been issued in the Efs.

Temporary (T) and preliminary (P) notices are distributed for the ENCs in the same way as other updates. We welcome feedback from our users regarding how this service works. Please send comments to

All ER updates are distributed through PRIMAR. For larger updates New Editions of an ENC will be issued. A New Edition may also be issued for technical reasons.

Terms Used

New dataset: ENC dataset that has not been issued for navigational purposes earlier.

Update: Amendments to existing dataset.

New edition: It also includes new data that have not been released earlier, in addition to all the previous updates.


Use of modern equipment makes it possible to extend the use of nautical chart information beyond what it is intended for. We strongly advise against this.

It is at all times the mariners own responsibility to familiarize themselves with and use the information in a chart in a responsible manner. Do take into consideration the constraints of the information the charts provides.

Report Feedback on Norwegian ENCs

Report errors, omissions or suggest improvements on the Norwegian Electronical Navigational Charts (ENC) in the web-based feedback system ENC Improver.

ENC Improver has been designed to provide users with a simple system to give feedback on Norwegian ENCs. Everybody who has an ENC license for navigation will receive user access to ENC Improver through their supplier.


  • On the map reporting (add a point on the chart and describe the problem)
  • Report positions (give the coordinates and describe the problem)
  • Give general feedback on ENCs

A monitoring system is in place to follow up received feedback. To submit feedback, Internet access is required.

If you have feedback on functionalities in ENC Improver, please send an e-mail to

In addition to ENC Improver, errors, omissions or suggestions for improvements on the Norwegian ENCs can also be sent to

5.3 ZOC-diagram

The data sources for an ENC will for many areas be based on old hydrographic data with inferior positional accuracy compared to what is possible with modern technology. These areas are identified by the use of Zones of Confidence (ZOC).

Norwegian ENCs are divided into the following user bands:

User bands
Navigational purposeNameScale RangeAvailable Compilation ScalesMatching Scale Range
1 Overview <1:1 499 999 3 000 000 and smaller 1 500 000 200 NM 96 NM
2 General 1:350 000 – 1:1 499 999 700 000 350 000 48 NM 24 NM
3 Coastal 1:90 000 – 1:349 999 180 000 90 000

12 NM 6 NM

4 Approach 1:22 000 – 1:89 999 45 000 22 000 3 NM 1,5 NM
5 Harbour 1:4000 – 1:21 999 12 000 8000 4000 0,75 NM 0,5 NM 0,25 NM
6 Berthing > 1:4000 3999 and larger < 0,25 NM

In digital charts the data quality is specified in Zones of Confidence (ZOC).

The ZOC diagram describes the quality of the bathymetry in the different areas. There are five quality categories in the ZOC diagram (A1 to D).

Until autumn 2013, mainly category B and C are used for Norwegian coastal waters based on the following classifications: ENCs with source data from older surveying (before 1960) are given ZOC value C, while ENCs with source data from surveying younger than ca 1960 are given ZOC value B.

From 1st of January 2014 the areas measured with multibeam sonar and which otherwise meets the requirements will be given the categories A1 or A2. The delimitation of the different zones will be added in the ENCs to always show which zone you are in.

Navigators must show great care when using (D)GPS and electronic charts in areas with older surveys as accuracy and completeness of the depth indicators are not in accordance with modern standards.

Additionally, the navigators should ensure that navigation at all times is conducted with good safety margins and in accordance with proper navigational practices.

For a full description: S57 IHO Transfer Standard for Digital Hydrographic Data.

ZOC Category
ZOC1 Position Accurancy2 Depth Accurancy3 Seafloor Coverage Typical Survey Characteristics5
A1 ± 5 m + 5% depth = 0.50 + 1%d Full area search undertaken. Significant seafloor features detected4 and depths measured. Controlled, systematic survey6 high position and depth accuracy achieved using DGPS or a minimum three high quality lines of position (LOP) and a multibeam, channel or mechanical sweep system.
Depth (m) Accurancy (m)

10 30 100 1000

± 0.6 ± 0.8 ± 1.5 ± 10.5

A2 ± 20 m = 1.00 + 2%d Full area search undertaken. Significant seafloor features detected4 and depths measured. Controlled, systematic survey6 achieving position and depth accuracy less than ZOC A1 and using a modern survey echosounder7 and a sonar or mechanical sweep system
 Depth (m) Accurancy (m)
10 30 100 1000 ± 1.2 ± 1.6 ± 3.0 ± 21.0
B ± 50 m = 1.00 + 2%d   Full seafloor coverage not achieved; uncharted features, hazardous to surface navigation are not expected but may exist. Controlled, systematic survey achieving similar depth. But lesser position accuracies than ZOCA2, using a modern survey echosounder5, but no sonar or mechanical sweep system.
Depth (m) Accurancy (m)
10 30 100 1000

± 1.2 ± 1.6 ± 3.0 ± 21.0

C ± 500 m = 2.00 + 5%d Full seafloor coverage not achieved, depth anomalies may be expected. Low accuracy survey or data collected on an opportunity basis such as soundings on passage.   
Depth (m) Accurancy (m)
10 30 100 1000

± 2.5 ± 3.5 ± 7.0 ± 52.0

D worse than ZOC C worse than ZOC C Full seafloor coverage not achieved, large depth anomalies may be expected. Poor quality data or data that cannot be quality assessed due to lack of information.
U Unassessed – The quality of the bathymetric data has yet to be assessed


To decide on a ZOC Category, all conditions outlined in columns 2 to 4 of the table must be met.

Explanatory notes quoted in the table:

1 The allocation of a ZOC indicates that particular data meets minimum criteria for position and depth accuracy and seafloor coverage defined in this Table. ZOC categories reflect a charting standard and not just a hydrographic survey standard. Depth and position accuracies specified for each ZOC category refer to the errors of the final depicted soundings and include not only survey errors but also other errors introduced in the chart production process. Data may be further qualified by Object Class 'Quality of Data' (M_QUAL) sub-attributes as follows:

a) Positional Accuracy (POSACC) and Sounding Accuracy (SOUACC) may be used to indicate that a higher position or depth accuracy has been achieved than defined in this Table (e.g. a survey where full seafloor coverage was not achieved could not be classified higher that ZOC B; however, if the position accuracy was, for instance, ± 15 metres, the sub-attribute POSACC could be used to indicate this).

b) Swept areas where the clearance depth is accurately known but the actual seabed depth is not accurately known may be accorded a 'higher' ZOC (i.e. A1 or A2) providing positional and depth accuracies of the swept depth meets the criteria in this Table. In this instance, Depth Range Value 1 (DRVAL1) may be used to specify the swept depth. The position accuracy criteria apply to the boundaries of swept areas.

c) SURSTA, SUREND and TECSOU may be used to indicate the start and end dates of the survey and the technique of sounding measurement.

2 Position Accuracy of depicted soundings at 95% CI (2.45 sigma) with respect to the given datum. It is the cumulative error and includes survey, transformation and digitizing errors etc. Position accuracy need not be rigorously computed for ZOCs B, C and D but may be estimated based on type of equipment, calibration regime, historical accuracy etc.

3 Depth accuracy of depicted soundings = a + (b*d)/100 at 95% CI (2.00 sigma), where d = depth in metres at the critical depth. Depth accuracy need not be rigorously computed for ZOCs B, C and D but may be estimated based on type of equipment, calibration regime, historical accuracy etc.

4 Significant seafloor features are defined as those rising above depicted depths by more than:

a. <40 m 2 m
b. >40 m 10% depth

A full seafloor search indicates that a systematic survey was conducted using detection systems, depth measurement systems, procedures, and trained personnel designed to detect and measure depths on significant seafloor features. Significant features are included on the chart as scale allows. It is impossible to guarantee that no significant feature could remain undetected, and significant features may have become present in the area since the time of the survey.

5 Typical Survey Characteristics - These descriptions should be seen as indicative examples only. 19 S-57 Supplement No. 2 June 2009

6 Controlled, systematic surveys (ZOC A1, A2 and B) - surveys comprising planned survey lines, on a geodetic datum that can be transformed to WGS 84.

7 Modern survey echo sounder - a high precision single beam depth measuring equipment, generally including all survey echo sounders designed post 1970." (See also 1.Cl.42).

To top